Foam glue 60 seconds Rhino 850 g, Kyiv

Glue-foam 60 seconds
It is a fast-hardening polyurethane adhesive foam used for mounting and gluing various building materials.

Appointment
Fastening of heat-insulating plates inside and outside the premises
Sealing of joints
Thermal insulation of building structures
Foam and gas blocks
Connection and installation of materials in industry and everyday life
Application method
Adhesive foam for 60 seconds is used in the temperature range -5...+35°C with a relative humidity of at least 60%.

It should be applied to the plates in strips with a diameter of 1-1.5 cm along the perimeter at a distance of 3-5 cm from the edge, and then crosswise.
Allow the plate to stand for 1 minute, then attach it to the wall and fix it until it sets (approximately 1-2 minutes). During operation, the cylinder should be periodically shaken.
Cured foam should be painted or plastered to protect against the damaging effects of UV radiation.(//tractor-service.com)
To ensure the maximum yield and obtain optimal physical and mechanical performance of the adhesive foam, the can should be kept at room temperature for at least 24 hours, thoroughly mixed immediately before use (shake for at least 1 minute) and applied to work surfaces previously cleaned of dust, dirt, grease, ice and frost. At positive temperatures, immediately before applying the foam, the surface should be slightly moistened. The working position of the cylinder is upside down.

The adhesive foam almost does not stick to the polyethylene film for 60 seconds, therefore, before carrying out the work, the surface on which the adhesive foam is not desired should be protected with a film. Unhardened adhesive foam can be washed off with a special cleaning liquid NOSORIG™ mounting foam cleaner, hardened adhesive foam can be removed mechanically. The cleanliness of the applicator gun greatly affects the quantitative and qualitative indicators.

Technical characteristics
Application temperature: -5...+35°C
Cylinder temperature: +15...+30°C
Time for unsticking: 3-5 min*
Hardening time: 5-30 minutes*
Time of complete polymerization: 12-48 hours*
Output: up to 55 h. m* *depend on temperature and air humidity.
Safety measures
Keep out of the reach of children. Do not use near sources of flame, hot surfaces and working electrical equipment. Use personal protective equipment when working. In case of contact with skin or mucous membranes, unhardened foam should be removed as much as possible with dry, clean materials and thoroughly washed with water, if necessary seek medical help. Do not puncture/damage the cylinder even after use.

Storage
Store in the manufacturer's original packaging with the valve up in the temperature range +5...+30°C at a distance of at least 1.5 meters from heating devices and sources of open flame, protected from moisture and direct sunlight. Do not heat above +50°C. The warranty period of storage is 18 months from the date of production.