The hydrostatic transmission controller is a compatible non-original analogue (aftermarket), designed for MERLO / JCB / Bobcat / Massey Ferguson / Sambron / Matbro equipment.
We offer a new hydrostatic transmission control unit compatible with a large
number of telehandlers and equipment.
Catalog numbers (for comparison):
035965, 058553, 059568, 10105827, 115985, 149290, MCE209B1003, MCE209B1023, NFPE
Advantages:
✅ Full compatibility with the original.
✅ Resistance to voltage surges
✅ Calibration via smartphone (Android, Wi-Fi)
✅ Adjustment of start smoothness and maximum speed
✅ Emergency driving mode - (up to 40% power in case of sensor failure)
✅ Built-in diagnostic system
Complete set: controller + adapter + manual + software.
Works immediately after connection. Suitable for construction and agricultural machinery.
(//tractor-service.com)
A little about the development:
This is not a "resoldered" block, but a completely new product developed by engineers in Ukraine:
actual software. Easy calibration of the device ensures smooth movement and longer service life of mechanical transmission components and lower fuel consumption.
- a modern electronic database
- connection to factory wiring without additional manipulations
- the possibility of calibration via phone (revolutions, pedal sensitivity, smooth start)
Connection consultation + warranty.
Call or write - we will help you choose and answer all questions.
PS/ Symptoms for which the unit should be replaced:
- the movement of the machine starts at 1100 and above revolutions/minute of the engine
- periodically stops in motion
- starts the movement when tapping on the hydraulic controller
- the red indicator on the hydraulic drive controller is constantly lit.
- the yellow indicator lights up constantly or does not blink.
The specified trademarks (MERLO, JCB, Bobcat, Massey Ferguson, Sambron, Matbro) are used solely to indicate the compatibility and purpose of the product. This product is not the original product of the specified manufacturers.