Rod d50*500 mm polyurethane for turning, Ternopil region.

Polyurethane cylinder, polyurethane rod

Purpose: workpiece for mechanical processing (turning) of parts of machines and mechanisms, washers, seals, cuffs

Hardness: from 75A to 95A

Diameter: from 20 mm to 300 mm

Length of standard rod: 500 mm

Type sizes: d20, D25, D30, D35, D40, D45, D50, D55, D60, D65, D70, D80, D90, D100

Advantages of polyurethane products over rubber:

High abrasive resistance
High tear and tear strength.
The ability to withstand higher loads
A wider range of hardness, i.e. 30 Shor A to 80 Shor D(//tractor-service.com)
High resistance to the spread of cuts
High resistance to atmospheric influences - ozone, oxygen, moisture, ultraviolet, heat
Low coefficient of friction (for hard varieties)
Long-term preservation of working sizes
The possibility of any type of fur. processing
There is no sticking of loose media
Advantages of polyurethane products over plastics:

Resistance to high mechanical loads.
Elastic deformation
High abrasive resistance
Reducing the noise level of working mechanisms
Adjustable coefficient of friction
Ease of formation of thick layers
Low cost of production preparation
Elasticity at low temperatures
Resistance to cold flow
Does not crack under high loads